Flying Butterfly Card

We tried a new style card today it is easy but looks complicated. Join us on our YouTube for the full tutorial. This we made up as we went along lol. Hope you enjoy. All the links to products we used as well as the link to the full tutorial are below.

YouTube tutorial: https://youtu.be/sns3ekce7ls 

Products used:

Bejewelled Stamp & Die Set: http://shrsl.com/1342f

Score Board: http://bit.ly/2NTdtXI

TH inks: http://bit.ly/2v3DBIr

We R Ruler: http://bit.ly/2AIDEKR

Mono Sand Eraser: http://bit.ly/2IrGTNu

Tim Holtz Scissors: http://bit.ly/2xbTxaB

Diamond Stickles: http://bit.ly/2LFz7SI

Foam Tape: https://amzn.to/2IOrGTH

Pick Up Tool: http://bit.ly/2zMUWKx

Art Glitter Glue: http://bit.ly/2FGCXmz

Wink of stella: http://bit.ly/2MbV9sW

Nuvo Glitter Pens: http://bit.ly/2IjhBkK

 Scor Tape: http://bit.ly/2H0Q5Yo

TH Ruler: http://bit.ly/2DK7dxO

Inks: http://bit.ly/2rjzVjg

TH Stamping platform: http://bit.ly/2xbTxaB

Neenah Cardstock: http://bit.ly/2Icxdqc

T-square Ruler: http://bit.ly/2I5AJPK

ATG Gun: https://amzn.to/2K9NM7c

ATG Tape: http://bit.ly/2Kd4diS

Basic Grey Magnets: http://bit.ly/2K3Hr9M

Made It Con Tennessee Classes: http://bit.ly/2Etx53T

Join Our Chalk Couture Team Or Make a Purchase:

https://edithwray.chalkcouture.com/store#

For info on the Maymay cruise: gina@cruisebrothers.com

https://edithwray.chalkcouture.com/store

Measurements

Card base is 8x6 score on all 4 sides at 1/2", cut corners slightly and fold in and glue together as if you were creating a pocket. 

Cut a piece of card stock at 5x7 and then a mat for this at 4 3/4"x6 3/4" glue these together. Measure in from each side (on short sides) 2" and make a mark with pencil. Come in from the end 1/2" make a mark. Do this on both the short ends. Connect the lines and this is the part that you will cut out to make the opening.  

Your pull tabs are cut at 1 1/4"x8" (2) and 1"x4 7/8" (2) glue the same sizes together to make stronger. Glue the short one to the end of the long one forming a T

Stamp on your pull tab now before you go any further. Put a light pencil line on the base beside the pull tab and this is the place you will stamp for the under neath stamp. 

Cut out your pieces for the top, butterfly, car, boat, airplane etc. Glue the top on the card using a non wet glue and then place your object on the pull tab at the end. Decorate as desired and you are finished. 

Hope you enjoy, E